- 积分
- 1891
注册时间2010-2-19
参与分
技术分
精华
TA的每日心情 | 开心
2018-9-14 12:16 |
|---|
签到天数: 23 天 [LV.4]偶尔看看III
|
附上英文说明书的全文，谁给说说到底怎么调整。。话说大学的英文都白学了，哎。。
Your new pack features a Futura Harness by Mystery Ranch. That allows the user to custom fit the pack to his or her torso ** it the most comfortable tactical pack for carrying heavy loads.
Fit is achieved by adjusting the yoke (the shoulder pad assembly) up or down along the pack to match any individual's torso length or for adjusting to be worn with or without armor.
The Fit Process
It is easiest to get the adjustment right the first time if you have a buddy help you. Use sleeping bags and jackets to fill up the pack so that it takes its full shape. IF you have that luxury. Try to keep the weight under 20 pounds; if there is too much weight in the pack it will be difficult to adjust.
Find the web-tab near the top of the back of the yoke. Pull up on this to and reveal the black plastic framesheet. When in place, this piece forms the framing for the upper yoke. It is also used to adjust the pack. Remove the framesheet and push it down between the yoke and the pack. You should hear the crunch of the Hook-and-Loop separating. With the framesheet in place, the yoke should now slide up and down freely.
With the framesheet separating the Hook-and-Loop panel, push the yoke down as far as it will go. Have your buddy lift the pack and hold it against your back. Orient the lumbar pad in the small of your back and, if the pack has a waist belt, place it over your hips and tighten the belt to secure the pack where you like to carry the load. Loosen the shoulder straps and have your buddy slide the yoke up until the outside notch (where the shoulder pad meets the yoke) is at the same height as the top of your shoulder blade (the large, flat bone on the back of your shoulder). This should put the base of the shoulder pad just below the top of your shoulder so that the first curve of the pad rolls out around your neck.
Once the yoke is in the proper place, have your buddy remove the framesheet (** sure the yoke does not move from where it is set) and replace it in the sleeve at the top of the yoke. Now that the adjustment has been made, and the black plastic sheet has been replaced, tighten the shoulder pads so the yoke is snug against your back and chest.
Lastly, reach up to the tops of your shoulders where the Load Lifter Straps attach to the top of the pack and pull them snug. This will bring the pack frame against the yoke and your back to stabilize the load. |
|
发表于 2011-9-5 15:37
楼主
